The easy buck is used for window and door jambs and allows nominal sized lumber to fit between the Expanded Polystyrene (EPS) panels. Primary uses are for doors and windows. Each bundle contains 100’ (30m) of Easy Buck. Quantity/Box 10 PCS Code # NUS-AWBCK-00...

The 4” (100mm) heavy duty tape is used for covering the interlock at the top of a wall to prevent concrete from flowing into the interlock. Quantity/Box 24 PCS Code # NUS-ATPHD-04 Dimensions 4'' x 72 Yd (96mm x 66m)

The 4” (100mm) protective tape is used for covering the interlock at the top of a wall to prevent concrete from flowing into the interlock. Quantity/Box 36 PCS Code # NUS-ATAPE-01 Dimensions 4'' x 72 Yd (96mm x 66m)

Fiber tape is used to provide additional EPS support for field cut forms that have more than 4” (100mm) of EPS extending past the last web, brick ledge forms in corner conditions, and radius panels. Quantity/Box 18 PCS Code # NUS-ATPCL-04 Dimensions 1'' x 60 Yd (24mm...

Designed to be fastened with two Nudura Hex head Screws anywhere on the Nudura fastening strip. This tie will accept Nudura Pintels and other smaller dimension pintels. Tested to meet ASTM D754 (USA) and CSA-A370 (CAN) std. requirements for masonry anchors. Surface...

Enables solid anchorage of veneer masonry through exterior foam to concrete core; tested to meet ASTM D754 (USA) and CSA-A370 (CAN) std. requirements for masonry anchors. Brick ties cast-in place (galvanized steel) Quantity/Box 100 PCS Code # NUS-ABRKG-00   Brick ties...

The V-Clip is used to connect a Nudura panel to a concrete floor. It allows the contractor to support the panel without additional materials used on the outside of the wall. Quantity/Box 250 PCS Code # NUS-AVCLP-00

Ten piece kits include five 1⁄4” magnetic nutsetters which can be used with any of Nudura’s hex head screws with steel flat washers, as well as five #2 red square driver bits. The durable plastic case keeps all the bits together in one convenient spot and limits...

The #10 screw can be used to connect the Nudura Alignment System to the forms. Other uses include attachment of strapping or buck material to concrete. Available in 2” (50mm), 2 1⁄2” (64mm), and 3” (76mm) lengths. Two 1⁄4” (6mm) nut drivers included per pail. Size #10...

The vertical joint clip is designed to connect the forms together at the vertical joints. It replaces having to tie wire or tape forms together while providing a solid connection using minimal amount of labor to install. Quantity/Box 200 PCS Code #...